373 Davis St.
P.O. Box 574
Meadville, Pa. 16335
814-336-2123
Fax: 814-336-2124
Email

Set-up instructions

TO CENTRALIZE DIAMOND POINT:
1. Loosen the thumb screw holding the rod in the spindle arm.
2. Set Diamond for "0" Radius.
3. Using Planer Gage and Parallel, place Indicator on Parallel over Diamond Point.
4. Rotate Swing Arm 10 to 15 degrees either way, gently tapping Slide until the Indicator show no movement
5. Tighten Set Screw

TO SET DIAMOND - For Desired Radius:
1. Remove Slide with Diamond Holder.
2. Place upside down over Gage Blocks, or Planer Gage on smooth surface such as a Hardened Parallel, allowing Diamond to merely touch surface. Tighten Thumb Screw By Hand Only.

In selecting Gage Blocks, Note Center Line Dim. Stamped on Tool. This Dim. is from the spindle center to top of Slide Block. Add or Subtract for desired radius.

FOR SETTING ANGLES:

This Tool uses a unique system for Angle Setting. Note the Circular Graduations in 5 degree spacings, numbered on every third spacing, for easier reading.

The Bearinng Cap is Graduated in 4 degrees, and numbered on every line. Thus, to set on 17 degrees, you swing to the 15 degree on the Circular side, Plus 2 Spacings on the Bearing Cap.

By using Care in lining up the graduation marks angles can be divided Very Accurately.

Inasmuch as any form consists of Radii or Angles or combinations, any form can be Very Accurately and Quickly dressed on any Surface Grinder.

By "sighting" the Diamond thru the Specially ground lens in the Spindle, the accuracy is greatly increased; not to mention the saving of time and costly Diamonds.

This a Precision Tool, and should be handled as such. Care must be taken to keep Diamond Slide dry and free from grit. Do NOT oil or grease Diamond Slide or Spindle Bearing.

 

Main | About Us | Dies & Gages
Fixtures & Spares | Short-Run Machining | Design Services
Clearview^© Dresser | Request Information | Contact Us